How to unlock the car
How to unlock the car
What to do if your car refusesrespond to the car alarm panel: the siren is silent, the signals of the turns do not blink and, most importantly, the door locks do not open? First of all, you need to try to understand what's the matter. There may be several reasons: a faulty remote or a dead battery, communication interference, a discharged battery or a broken alarm unit. Start looking for damage using the method of transition from simple to complex.
Instructions
1
First, check the key chain, replace the power supply in the console. If the machine does not respond, try unblocking it with the second keyfob from the alarm set.
2
In the event that the car does not respond to anyone of the key fobs, use the key. After opening the door, turn off the siren button with the Valet button (strictly follow the instructions on "Alarm removal of the alarm without a remote" instructions for signaling). If your actions are correct, the siren will subside, and the alarm will respond to the console.
3
You turn on the ignition, and the car refusesStart up? At the same time, the lamps on the dashboard are weak, and the alarm always gives a "voice"? These are signs that the battery of your car is dead. If you have an autonomous siren, then to call it to "order" is not difficult: just use the key. Otherwise, to disconnect it, you need to disconnect the battery terminal. Then remove and charge it (you can "light" the wires from the neighboring car, if it "happened" next to it). After completing this procedure, do not forget to reprogram the console, because the alarm settings are lost due to the removal of the battery.
4
Often, this defect alarm occurs in severe frost, especially if the battery is old enough or weak. At low temperatures, do not put the car On security for a long time.
5
If all of the above did not help, find the alarm box under the torpedo (dashboard) and disconnect all the wires from its connectors. Now try to start the car. If it does not work out, then it can mean thatignition, a starter or a gasoline pump are blocked, and they need to be disconnected. To do this, find the wires that go from the main signaling unit to the wiring harnesses of the vehicle. If the standard wire is connected to the wires from the alarm, then to unlock them you need to disconnect, and connect the ends of the regular wire together.
