LovesTheTeam.com

Bob haircut

In order to make quads, not necessarilygo to the salon. A firm hand, sharp scissors, confidence in action - all that you need. For a haircut, the hair must be clean and damp: rinse with a good shampoo and conditioner. Divide the head into seven main zones: left temporal, right temporal, anterior central (located between the temporal zones), the left part of the vertex, the right part of the vertex, the left side of the occiput, the right side of the nape. First you need to cut the desired length of the hair. The traditional square finishes just below the chin, but it may well be longer or shorter. It should be combed away from the selected zone a strand one to three centimeters wide and cut. Scissors during cutting should be kept parallel to the floor. Do not overstretch your hair: the result should be natural. First cut the front zone, then the occipital. In order for hair to be the same everywhere, you should use a long comb or ruler. The front central zone of the hair (frontal) is trimmed last. After the haircut is complete, dry the hair. Use tongs or straightening iron to make the hair straight and smooth. Cutting quads looks neat, elegant and stylish. It is the basis for elongated, graded, torn and other types of quads.

Stacking of elongated square with bangs

Before applying the styling, apply on hairvarious means: thermal protection, hair foam, mousse for hair. You can choose one or the other. Laying begins with a bang: on all length blow it with a hair dryer. Then wind the bangs to the roots with a round comb. Keep the hair on top of the comb. After that, start laying the back of the head. Separate the upper and lower hair with a clip-clamp, lay the locks with a round comb and a hair dryer. Lateral zones lay in the same way, winding them on the comb. Hair twist inside. Move from the lower strands to the upper ones. To ensure that too long strands do not untwist, use a hairpin or invisibility clamps. "Skeletal hairbrush" is used to lift and lay hair at the roots, thereby creating a volume.

Stacking the graded square

The graded square can also be laid whenthe help of a round brush and a hair dryer, but the strands should be twisted outward, and not inward. In addition, you should use ironing. So, first apply to the clean hair foam over the entire length. Then select a small strand of hair, and remove the rest with a clip-clamp. Turn the strand off with the iron upwards and fix it with lacquer. Do the same procedure with each strand on the head. At the end, sprinkle your hair with a hair spray.