Tip 1: How to open a lock on a briefcase
Tip 1: How to open a lock on a briefcase
Portfolios, travel bags, and also suitcases are supplied with locks. Some of them do not have protection against unauthorized opening in general, others are locked with a key or they allow you to enter a code.
Instructions
1
To open a lock equipped with a spring-loadedplastic or metal key, just click on it. Its upper edge will drop below the level of the bracket, and the upper part of the lock with the key can be pulled out.
2
Other locks are equipped with folding levers,which are also spring loaded. Pull down or sideways a key on the lock case (sometimes it needs to be pressed). The pin inside the lock will come out of the loop on the lever, and it will bounce off under the action of the spring. Similarly, open and lock, holding the loop is not on the lever, but on the top cover of the briefcase.
3
Sometimes the key for opening the lock itself is the key. To remove it, pull it to the side opposite to the opening direction. To open the lock, insert the key-key into the groove and press it.
4
Also in portfolios, travel bags andsuitcases there are locks, opened in a traditional way - with the help of a key. To do this, insert the key into the borehole and rotate it to a position where the lock mechanism allows the key to move. To lock the lock, lock it, and then turn it into the locking position and remove it. Note that some designs of such devices allow locking without a key, so be careful not to lock the key in the portfolio itself.
5
Code lock open, first by typing the code andonly then moving the key. To change the code, first set the current one, then click on the ledge (it can be on the inside), then, without releasing it, enter the new code. Then release the ledge, and then, without locking the briefcase, make sure that the old code has stopped functioning, and the new one has started. Note that such locks are not equipped with any protection against code search. Beware of intruders who can consistently check all 99 or 999 possible variants of the cipher.
Tip 2: How to open the coded lock of an entrance
Code Castle is a locking device,unlocked not with a key, but with a special combination of numbers. The code can be set on the cylinder or typed from the keyboard. Undoubtedly, such a device is more reliable than a conventional lock, opened with a key, but sometimes the increased reliability of a code lock can play a cruel joke with you. What if you forgot the opening combination? This kind of trouble often happens with older people, and not only with them.
Instructions
1
If you have a mechanical button Castle, carefully examine it. Often, when you consume the same code for a long time, certain buttons on the lock appear to be wiped out or, on the contrary, darkened. Typically, these are three buttons, in some cases two or four. Also examine the lock surface directly around the buttons. Paint on the panel in places where frequent pressing occurs may be damaged, which will also indicate the opening numeric combination.
2
If outwardly all buttons look the same, and theirthe surface does not differ from each other, then use the method used in forensics when searching for fingerprints - consider the surface of the buttons at an angle, with oblique light. If the opening combination has not changed for a long time, then in this way you will be able to identify buttons that differ in color from the others. Reception, however, is only suitable in the daytime and in sunny weather.
3
In some cases, in order to learn the codecastle, it is enough to carefully consider the surface of the wall around the door to the entrance. Often, elderly people, who have a bad memory, make barely noticeable notes with a pencil at the level of their eyes, recording the code of the front door to make their life easier.
4
Another technique assumes that you havegood tactile sensitivity. Consistently click on the lock code buttons, trying to find out which ones are pressed more easily than others. Usually those that most often work have more stretched springs, so it is relatively easier to press them.
5
When using any of the aboveways to keep in mind that, as a rule, in opening combinations, numbers that are located only in one row and numbers far apart from each other are extremely rare. Usually the combination is chosen in such a way as to be ergonomic, that is, convenient for pressing the fingers of one hand.
Tip 3: How to open the lock on a suitcase
Every year, travel suitcases with codelocks becomes more and more. And this is dictated by security considerations. Of course, if a thief steals the suitcase itself, he can simply rip open its walls and pull out the contents. However, it is extremely difficult to do so that the owner of the suitcase did not notice. But it's easy to open the zipper and pull out, for example, a purse, if there is no lock on the suitcase. However, sometimes people ask themselves how to change the code installed by the manufacturer and then open such a suitcase.
Instructions
1
First you need to determine what type of lockinstalled on your travel bag. Locks are hinged and fixed. On the type of this device is located on your suitcase, the method of its opening depends, as well as the installation of the code cipher.
2
By default, the manufacturerset the standard settings for all locks - a combination consisting of one zeros. So if you have not changed the combination yet, scroll the wheels on the lock until each one stops at zero. The lock will be removed and you will be able to open the suitcase. To change the cipher, proceed as described below.
3
If the lock on your suitcase is of a fixed type,find the button that is responsible for the lock, which, as a rule, is on the side wall. It looks like a small lever or a groove. Find a sharp object and press it on the button or move it to another position (to the right upwards), if it's a lever. Without releasing the button (switch), enter by rotating the dials the necessary combination, remember it, then release the button or lever, close the suitcase.
4
In the case of a padlock, proceed as followsway. It is necessary to pull the metal arc, then rotate by 90 or 180 degrees (depending on the manufacturer). The castle will open. Further, the essence is press the same arc inside and do not let go. On dialing disks, fix the number that you want to use as a cipher, remember it, then release the arc.
5
If the code of the castle you for some reason forgotten,open a suitcase will be very problematic. First try to sort through the possible combinations. Sometimes the dial turns smoothly. You can hear a slight click - this will indicate that the figure is correct. In the same way, select the numbers on the remaining dialing disks. If nothing helps, go to the workshop.
Tip 4: How to make a combination lock on the door in Minecraft
A lot of gamers who love multiplayeroption Minecraft, often wondering about how to better protect their home and the belongings in it from the attempt of griefers. One of the solutions to this problem will be the creation of a code lock on the door.
Creating a simple constipation
Implementation of this intention will be a taskvery laborious and requiring a certain amount of resources based on red stone. It will certainly be the dust of the redstone, playing the role of wires in any mechanical device, as well as red torches. In addition to them, repeaters (repeaters) can also be used - depending on which particular model of the lock is chosen. If the gamer prefers the least expensive way of protecting his home, a door lock with a code without digits will do. Open the entrance to the dwelling (or, for example, in the room with the most valuable things) there will be a certain combination of levers. Which one - choose the player himself. However, it is better to have at least five or six of them in total - so it will be more difficult for outsiders to pick up the code. On the wall of the house next to the door, you need to set the desired number of levers, press the ones that will open the door, and on the opposite side, torches. On the contrary, those mechanisms that turn out to be unused in a combination, you must put any solid blocks. However, the secret is to install them not directly at the level of inactive levers, but one cube below. Across this block system, you should run a path from the dust of the redstone. After a couple of blocks from this design, it is worthwhile to mount the lamp, and next to it from the back of the wall to put perpendicularly to the pair of blocks on top of which (at the level of the lamp) to insert a red torch. The light will serve as an indicator of the set of the correct combination. Now you should close the whole rear of the mechanism with another wall from very strong blocks (ideally - obsidian or even bedrock) - so that the other player does not have the opportunity to spy on the entered code. After that, from the mechanism it is necessary to bring the path from the redstone to the door and also to disguise it with something.Complex door lock
However, it is important to understand: The chances of breaking into the entrance to the dwelling will depend on the degree of complexity of the locking device. Therefore, it is better not to economize on resources and create a more intricate design. To start on a steep wall through gaps in one block, you need to install nine buttons. They will correspond to the order that the numbers on the code lock in real life (the top row - 7-9, the middle - 4-6, the lower - 1-3). By the way, you can put a tablet there, providing it with an inscription explaining everything that is said above. From the back of the wall opposite each button, you need to place red torches, each of which then will need to conduct the electric circuit from the redstone and bring them to one line. In each of these wires, you will most likely need to use at least one repeater. Its delay is set on as many identical devices were involved in each particular circuit. The next step is to select the code that will open the door. It can be any three digits. In accordance with the order in which they will be pressed, it is necessary to select the delay of the repeaters coming to them. For the first of the dialed digits, it should be set to three, for the second to - two, for the third - to one. This is necessary so that the locking mechanism operates. In the general circuit it is absolutely necessary to put the inverter (gate NOT), so that the signal to the door comes only if the correct combination is entered. Next, the wire should go to any memory cell (even the simplest is used, for example, from blocks in the form of a letter G with two buttons and red torches), and from it it should be divided into two branches. The first will go to the door, the second - to the floor button, which allows you to open the locking mechanism after entering the code. Now you have to draw the signal so that it goes straight to the entrance, but does not reach a special solid block playing the role of a cleaner. But the latter must be connected directly with the opening button - so that after the player's passage into the room the combination he typed did not keep the door open, and that could be locked again. The opening mechanism is very simple. Here simply goes a wire from Redstone to a red torch playing the role of a castle. In order for the above circuit to work, no doubt, you must periodically insert repeaters on it. If the gamer does everything right, he will get a very reliable code lock.Tip 5: How to open a portfolio
A portfolio is an essential attribute of a business person. One of the elements that do not determine, but significantly affect its design, is its castle. It also depends on the safety of the contents of the product - the more reliable the lock, the more difficult it is to open the portfolio.
Instructions
1
One of the most common locksis magnetic. In this case, simply close the portfolio, putting one side of the lock on the other, it opens very easily. Such locks are more decorative, rather than functional - if the contents of the portfolio weigh a lot, then it can open itself without assistance.
2
Rarely, but still meeting, is the castle,Made in the form of two balls welded to the metal frame of the briefcase cover. To open such a lock, it is enough to apply force in one direction to one of the balls, while simultaneously pressing the other in the opposite direction.
3
Another option is a lock-latch. In order to open such a lock, you need to pull a special button to the side. This type can also be equipped with a magnet for greater convenience. Often, portfolios are completed with a lock, for which you need a special key. In this case, the reliability of the device depends on where the lock is located. If it is at the very edge of the portfolio cover, it can easily be broken, but if it is sewn two or three centimeters from the edge, it is sufficiently functional and reliable.
4
Lock-latch can also be completeddigit code. In this case, it is not opened with a key, but with a set of special combinations on rotating drums. By building the desired numbers in one line, you can open it.
5
One of the most reliable is the castle,which consists of a latch placed on a metal frame, a numeric code and an additional lock that is opened with a key. In order to open this portfolio, you need to spend a lot of time - first you need to pick up a digital code, then open the portfolio with a key and only then move the latch.
Tip 6: How to transparently send notes in a lesson
Many times pupils come across that theircatch on the transfer of notes to other students during the lesson. The situation here is delicate. Using a few simple tricks, you can send notes to friends and not be noticed for many years.
You will need
- Paper for notes, pencil
Instructions
1
When at the lesson you have a desire orneed to ask a neighbor something, and the teacher makes everyone silent, do this. On a scrap of paper of the smallest size, write down what you would like to say. This can be a regular note paper.
2
The most important thing is to do everything sensibly. If you have an open diary, textbook or notebook in front of you, put a note on top and write. Usually everyone is caught on the fact that they write somewhere on their knees or under the desk, looking around. But, when a teacher is standing in front of you, it is supposed that there is an open notebook or book on the desk.
3
Once you wrote everything you wanted, drop itA note on the floor, while the teacher turned away or talks on the phone. You can pretend that you have forgotten something in your bag or briefcase and are going to get it. Then drop the note next to the foot. Then step on her sole. Usually a note can be handed from hand to hand, but this is a master class.
4
If a person sitting next to you can be trusted, shove a piece of paper under his feet and ask him to betray the intended recipient. Do it imperceptibly.
