LovesTheTeam.com

You will need

• - old jeans;
• - thread in the color of the fabric;
• - sewing accessories;
• - sewing machine.

Instructions

1

For the manufacture of a simple,zipper will need old jeans with preserved pockets in the integrity. Around the two pockets, the tailor's crayon draws a contour, stepping away from the edges of the pocket 3 cm. The details are cut out along the contour, put face down and sewn the zipper gartered from the jeans to the tops of the pockets. After that, the pockets are folded upside down and the remaining sides are left on the machine. The finished product is turned out, a cover is obtained with two outer and one inner pocket. To the case, you can sew an eyelet to wear it on your wrist like a handbag, and to the outer pockets sew small pieces of fixing tape, Velcro.

2

Some modern phones have enoughlarge sizes, due to what can not fit in a cover made of pockets. Therefore, for making a cover for a similar phone, it is necessary to make preliminary measurements with the obligatory allowance for allowances for seams. Based on these measurements, two pieces of old jeans are cut out, and the inner side of the cover can be made from a fabric of contrasting color. In this case, you will need four parts: two jeans, two of the chosen fabric. Each pair of details is folded inward with the faces, spreading along the long sides.

3

The inner layer of the sheath is turned out so that the seam is notwas visible. The unreinforced detail of the jeans is inserted into the inner layer, both layers are straightened and sewed obliquely along the corners. After that, the cover is turned out, as a result of which the jeans layer is on top, and the seams of both parts are inside. At the finished product, the upper edge is tucked and stitched, a loop and a beautiful button are sewn onto the front side to fix the loop.

4

Also easy to make and cover for your phone inas an envelope, with a safety valve. To produce it, you need a wide flap of denim fabric, which in folded in half corresponds to the size of the phone, taking into account the manufacture of the upper valve. The fabric is folded with the front side inward, is spread along three sides: two side and one bottom.

5

The upper free edge of the tissue is cut out in the formtriangle or semicircle. The edges of the valve are folded and poured, or trimmed with decorative braid. If there is no desire to process the edge, then you can pull out threads from it and get a fringe, organically combined with a denim fabric. The fastener for the valve can be any: a button and a loop, "Velcro", buttons, ties. The finished product can be decorated with embroidery, applique, beads, etc.