How to remove the handle of the mixer
How to remove the handle of the mixer
Some types of plumbing work can be performed independently, without the involvement of a qualified specialist. This, first of all, relates to the repair or replacement mixer in the kitchen or in the bathroom. In each case, the dismantling of the device has its own characteristics, which depend on the type mixer. To begin repair, in any case, follows with the detachment of the handle of the crane.
You will need
- - knife;
- - Screwdriver.
Instructions
1
Determine the type mixer, handle which you have to withdraw. The removal of the handle will depend on the type of device and how it is fastened. Today, most often in household use single-lever mixers, but there may be those that have two swivel handles on the respective valves.
2
Before proceeding to disassemble mixer, turn off the water supply to the system,pipe faucet. It is important to correctly follow the sequence of actions: first open the water, then close the valve on the pipe, and when the water stops walking, close the mixer lever. Otherwise, unnecessary overpressure may form in the pipes.
3
Before removing the handle from the single lever mixer, examine it. In the front part, under the handle, you will see a stub (usually it is of two colors, red-blue). Use a knife or a screwdriver to remove the plug and set it aside.
4
In the opened hole there is a screw. Insert a screwdriver into its slot and turn it slightly counter-clockwise. In this case, the decorative handle mixer free. Now remove the handle (usually it is not difficult). After that, go to the dismantling of the mixer, if this is part of your plans. Putting the pen on its rightful place is carried out in the reverse order.
5
If you have a mixer equipped with twoseparate valves for cold and hot water, then the technology of disassembling the handles will be somewhat different. First, detach the decorative cap that closes the place of attachment of the handle. To do this, it is necessary to slightly pick it up on the edge with a sharp object, acting carefully so as not to scratch the surface.
6
Under the cover you will find the screw with which the handleis attached to the body of the device. Remove the screw from the thread and set it aside. Now the handle can be removed. If it lends itself slightly, twist it slightly in opposite directions to swing. Do the same with the second valve. Disassembling the handle mixer completed.
