LovesTheTeam.com

You will need

• - bending;
• - fittings;
• O-rings;
• - Round file;
• - calibrator;
• - scissors for metal plastic.

Instructions

1

The ambient temperature at which the installation of metal-plastic pipes should be performed must be at least 10 degrees Celsius.

2

Pipes can not be broken and flattened during installation. If this still happened, then straighten the pipeline with a rubber or wooden hammer. However, you can do this only once.

3

Make sure that the pipes do not twist and do not experience horizontal stress. To ensure that the holes are not clogged, cover the loose ends with plugs.

4

To make a bend use a special spring, which will protect the pipe from kink. It is best to use a special tool - a pipe bender.

5

Cut a piece of pipe of the required length. Use special scissors, since any other tool not designed for cutting this type of pipe can damage the protective layer of the pipe and make the cut uneven. This, in turn, will lead to problems with the connection and in the future will cause a leak.

6

To implement a reliable and high-qualitySeal on the fitting of the fitting, use O-rings. In order not to damage them, flare the tube with a calibrator. Connect the pipe to the fitting using a nut and a clamp.

7

Beginning the installation, with the help of sharpeneda metal drill or a round file inside the pipe along the edges, remove sharp edges so that they do not damage the rubber bands. Otherwise, the connection will become leaky.

8

Using the calibrator to dilute the end of the pipe,put it on the fitting of the fitting. Carry out a tight alignment with respect to its acceleration, return the clamping yoke. Then return the fitting nut and start to spin. Do this carefully until a characteristic crackle appears.

9

For the connection of metal-plastic pipes tosurface, use special devices - clips. For smooth, accurate attachment of clips, perform the marking and screw them with screws. The pipe easily snaps into the clips with a slight pressure on it.