LovesTheTeam.com

You will need

• - felt;
• - glue;
• - double glass;
• - double sided tape.

Instructions

1

Among the cars Zhiguli the most successful modelsrecognized "nine" and "ten". The heat leakage from the salons of these machines is due to large slots between the trunk and the doors. Therefore, for their insulation, it will be sufficient to treat door seals with silicone grease and change the rubber band on the trunk.

2

As for the other brands of Zhiguli, for theiryou will have to spend much more time and energy. To begin work on warming of interior in this case it is necessary with obligatory extraction of back and forward seats, and also a ceiling and the forward panel.

3

Now you can cut the patterns on the ceiling fromyour chosen thermal insulation material, which is best used by felt. Before fixing the heater, treat the surface of the ceiling with glue, the choice of which must be approached with all responsibility, since the quality of the work depends on its quality. To glue a heater it is necessary accurately. Otherwise, poorly glued thermal insulation material can cause condensation on the inside.

4

Next, heat the back of the rear seat, thenseal the front panel separating the interior and the engine compartment. At the end of the insulation of the interior with heat insulation material, the bottom of the car is pasted. After the adhesive has completely dried, you can reinforce the removed parts of the car interior.

5

To make the Zhiguli warmer, thermal insulation onlyone salon will not be enough, so you need to take care of the thermal insulation of its glass, which will avoid the formation of frost on their surface. Solve the problem will allow the installation of double windows on the front and side windows. For this, it is best to buy the same glass that is in your car. In this case, it is not necessary to buy it in stores, since double glass can be bought with hands for half the price.

6

If you feel sorry for spending your money to buysuch glass, then you can manufacture it yourself. To do this, cut out of the most ordinary glass rectangles or squares, what you need, and fasten them from the outside. Do not forget about the gasket between the two panes, which you can use as a double-sided tape, a piece of plasticine or an eraser. This is necessary to maintain the tightness between the two glass elements.