Tip 1: How to install the antenna correctly
Tip 1: How to install the antenna correctly
Car antenna - the device, thanks towhich in a traffic jam can not only be bored, but also listen to the radio or watch TV. Proper installation of it not only helps to achieve the highest quality signal reception, but also extends the service life of the antenna.
Instructions
1
Take care of the antenna's close contact with thethe surface of the car. The quality of the signal depends on this. Some materials that are used to make car body elements or are used to cover it are weak conductors, so installing an antenna on them will reduce the quality of its work. One of these materials can be called carbon.
2
Install the antenna on the roof of the car. This will make it possible to achieve the most stable reception of the signal - the maximum rise above the ground is of great importance for the effective operation of this device. In addition, in this position, the antenna remains stable when driving even at high speed. Mounting the antenna on the hood or trunk will reduce the quality of the antenna, as well as installing it for low tide.
3
Avoid electrical interference. They can appear if the antenna itself or its cable is too close to various electrical appliances, ignition system and other equipment.
4
Protect the antenna contacts from oxidation. This can be done with a silicone sealant. Do not use plastic covers - over time, condensation will accumulate under their surface, which can lead to the failure of the antenna.
5
Hide the cable leading to the antenna, into the car interior or inside the body, under the lining. The shorter will be the open portion of the cable outside the machine, the better the signal will be.
6
Watch the position of the antenna - it should bestrictly vertical. So its radio emission will be directed only parallel to the ground, not upwards or towards the driver and passengers. The slope of this device for decorative purposes may affect the quality of the signal. The closer the antenna to the horizontal position, the greater the chance that it will be completely useless.
Tip 2: How to install the antenna
Not so long ago, residents of small towns, towns,villages with envy looked at their more successful acquaintances and relatives - inhabitants of large cities. After all, they had the opportunity to choose television programs from a much larger number - for every taste. Today your place of residence does not matter. For a pleasant viewing experience, you just need to choose the right satellite antenna and install it correctly.
Instructions
1
Installation of a satellite dish.First you need to choose the location of the antenna. This place must satisfy the following conditions: • ease of fastening (it is desirable to do without using stairs, lifts) • unavailability for outsiders (the higher from the ground, the better) • the shortest distance to the location of the television receiver. For its definition, look at the location of previously installed antennas in the apartment building. They are usually aimed at receiving the maximum television signal. The choice is made, we have antenna on the wall of the house next to the balcony, this place completely satisfies all the above requirements.
2
With the help of a perforator, we drill a hole for bolts with riving bushings, with which we fix the antenna bracket. The attachment must be reliable and rigid. Pre-assembled antenna install on the fixed bracket,pre-connecting the cable with the F connector to the converter. We close it with a waterproof cap. The antenna fixing nuts are not tightened to the end so that you can move it from left to right, from top to bottom and vice versa.
3
We connect the converter to the satellite receiver, and the receiver, respectively, to the television receiver. In the main menu of the satellite receiver we find the mode "antenna installation - manual search". Turning antenna Left - right, we find the signal from the satellite. If the signal does not appear slightly change the angle of the antenna and turn it again left-right. After achieving a stable signal, tighten the fastening nuts, making sure that the signal does not weaken.
4
After that, in the main menu of the satellite receiver set the mode of "automatic tuning". Satellite dish installed, a pleasant stay!
Tip 3: How to Install the Antenna at Home
It happens that the television receiver shows the picture very fuzzy. The reason lies in the uncertain reception of the signal. In most cases, the problem is solved with a new antenna.
Instructions
1
Order a connection to DTV television or ask a coupon from friends or friends, if necessary. In our country, it is usually possible to avoid this procedure.
2
Find two aluminum cans with a capacity of 0.5 liters. You can use a container of beer or kvass. It is advisable to wash the jars. They are ideal for intercepting a signal in the range from 300 MHz to 3 GHz. The main thing is to connect them in the right way.
3
Cut approximately one third of each can - they will be enough for a good signal. At the same time, you can use the whole of the bank, if you do not want unnecessary complications. Try it.
4
Tie a wire to each bank. It can be screwed with a bare part to the can of the can. The problem of connecting the cable to the banks will consist in the fact that the key in the cans comes off very easily. So wind the screw with a wire and screw it into the jar or make a hole in the jar. The length of the cable should be more than 3 meters. It is best to use a special television cable. Cut off the soft shell and clean it of the shielding braid and protective layer.
5
Find the tube of plastic or cardboard. In it, set the cans so that they hold tight. In extreme cases, the cans can be glued. In the middle of the tube, make a hole where the wires connected to the banks pass. Banks can also be attached to a clothes hanger or a stick. The main thing is that they are on the same line. Distance between banks calculate by experience. Here everything depends on the size of the cans and the distance from the television transmitter.
6
Connect the wires to the antenna connector. Take care that the wire of the braid does not get into the place of connection - this will dramatically worsen the signal level. The antenna is ready, now you need to set it so that the signal is as strong as possible. Connect the aerial plug to the television set.
Tip 4: How to set up satellite internet
Instantaneous WAN access, wirelesstechnology of data transmission, high-definition digital television, connection to any satellite, recording of your favorite programs - all this is possible thanks to satellite The Internet. The most acceptable method of connection is asynchronous, when the request is transmitted over the land line, and the response is sent to the computer directly from the satellite.
You will need
- DVB board, offset satellite dish, converter, subscription with satellite Internet service provider, telephone line (regular, 3G, GPRS, ADSL)
Instructions
1
Connect the DVB board to the computer. It is necessary for converting signals coming from the converter to a computer. This board can be stand-alone, or can be connected using a PCI slot. After installing the board, you need to install and configure the driver for it. The most popular and reliable are the TT-budget and Twin Han boards.
2
Set and adjust to the selected satellitesatellite dish. It is the offset type of the antenna that is easy to install and configure. The choice of the satellite coordinates depends on the selected provider. To configure the antenna, you can use the special Satellite Antenna program.
3
Install a special program to exitInternet TechniSat DVB-PC. Enter the required satellite parameters in the program settings, and then tune to the signal. If everything is correct, then the program icon will turn green. Next, configure the OpenVpn program, which encrypts and establishes connections between the server and the client. If the program icon is green, the connection to the remote server is established and the VPN connection is configured correctly.
4
Enter the required settings for the mobile Internet, then check the network access.
5
Enter in the network settings of the Internet browserthe proxy server values received from the ISP. Thus, all requests for access to information will come via land lines to its server, and the answer will come through a satellite. In this case, the traffic of queries will be minimal. The bulk of the traffic comes from incoming information.
