How to ride an automatic machine

How to ride an automatic machine

Cars with automatic transmission firmlyentered the life of car enthusiasts due to ease of management. Although many car owners with MKPP argue that there is nothing more reliable and convenient, more drivers are transplanted to a car with automatic transmission. The majority of driving schools, despite the changes in the legislation, allowing to receive special rights for drivers of cars with an automatic box, continue to train their customers to travel only by mechanics. Therefore, many people buying a car with automatic transmission do not know how to ride an automatic machine.

How to ride an automatic machine

Start of driving when driving on a car with automatic transmission

Like a car on a mechanic, to drive a machine with an automatic machine, you need to start it and warm up the engine. The colder in the street, the longer it takes to wait before driving.

It is important to remember that you can start the car with automatic transmission only when the lever of the box is in the neutral position N or P.

To be able to move, you should switchin the appropriate mode. To ride forward - put the lever in position D, back - R. Press the gas only after you feel a slight push, meaning that the car was removed from the "neutral".

It is also important not to forget to take the car off the handbrake.

How to drive with a machine: pedals

In the car with automatic transmission unlike the car withThe mechanical box has two pedals: gas and brake. To operate the automatic machine you need only one foot, keeping it on the gas pedal. Another leg at this time should be to the left of the brake on a special stand. Otherwise, when there is a danger on the road and the need for braking, you can depress the accelerator pedal by inertia. To brake on the car with automatic transmission, it is necessary to remove a foot from gas and to press a brake pedal.

How to ride a car with a gun: gearbox

The automatic transmission has several modes.

When the lever is in the P position, the drivingthe wheels and shaft are locked. This mode is used for parking and long stops. Switch to parking only after a complete stop. To move the lever to this position, you must hold the brake. If you turn P on while driving with a machine, the car may break.

If the car is put in parking mode onrelatively flat surface, the use of a hand lever may not be necessary. If the slope is steep, then to relieve the load on the mechanisms of the car, you can additionally use a handbrake.

To put the machine with the machine in the P mode with the handle, you should proceed as follows:

- press the brake, pull the lever;

- release the brake (while the car can jerk a little from the spot);

- Press the brake and put the lever in R.

To remove from the handbrake, you need to switch the box to the driving mode, and then release the handbrake while holding the brake.

To turn on the reverse on the machine with the machine, you must completely stop the car, and while holding the brake, move the gear lever to the R. position.

There are many disputes among those who do not know how to drive correctly on the machine, about the situation of N.

This mode is used to move the machine to theSmall distances, for example, in the service, with the engine running. Many believe that when driving downhill from the hill you can save gasoline, including neutrals, but it's not. Since at the end of the slope it is necessary to turn on the engine again, and this gives an additional load to the box. Also, do not put the car in N during stops, for example, at traffic lights.

To ride the machine at any speed, you need to use the mode D.

On a bad road or when towing a car, you can turn the box to position 2. This will prevent the car from switching to a transmission higher than the second.

If you are going to accelerate the car to 80 km / h, then use the gear limit is not recommended.

If the road conditions do not allow you to travel at a speed of more than 15 km / h, then you can turn on L, then the car will only go on the first gear.

In machines with automatic machines, there may be a specialOverDrive mode (O / D). If this button is recessed, the car can switch to the fourth speed. This mode is necessary for driving on long lifts and overtaking, when rapid acceleration is necessary.

On cars with automatic transmission there is also a kick-down mode. It turns on if there is a sudden depression of the accelerator pedal. Thanks to this, the car accelerates sharply, however, when moving from the spot, it is not recommended to use this function.

In SNOW mode, it is convenient to drive in winter. Due to this mode the machine starts to move from the second speed, which reduces slippage.

In this way, to drive a machine quite simply. The main thing in this business is practice.