LovesTheTeam.com

Instructions

1

Before setting up the HBO, check some engine components. The compression in the cylinders should be 6.5 kgf / cm2. Check all the candles and wires and make sure the path is completely tight.

2

Switch the gas reducer to the "Gasoline" mode andStart the car. After warming the engine to operating temperature, set the idling speed to 800 rpm. Then switch the gearbox to neutral.

3

Please note that the order of adjusting HBO directlydepends on the type of dispenser. With a two-section system, unscrew the first section to "maximum" and the second one to "minimum". Screw the single-section dispenser to "maximum". Tighten the idle screw until it stops and make five turns back.

4

Switch the button to the "Gas" position, startmotor vehicle and with the help of the pump, set the speed to 1500 - 1700 per minute. After that, completely "drown" the adjustment knob so that the engine works confidently when the suction is off.

5

Now adjust the sensitivity of the gasreducer. To do this, carefully unscrew the sensitivity bolt, and when this no longer affects the idling speed, wrap it back in two turns. Press the gas accelerator sharply to check the HBO adjustment. The acceleration of the engine should be powerful.

6

Adjust the dispenser screw to determinethreshold, at which there is a change in speed. After this, turn the screw half a turn. In a two-section dispenser, the first chamber is similarly regulated. When adjusting the second chamber, the screw position is reduced by a quarter turn.

7

Invite an assistant who shouldpressing the accelerator pedal to set the engine speed to 3200 - 3700 per minute. At this time, tighten the adjusting screw a quarter of a turn. Repeat the procedure until there are no dips. When this happens, unscrew the screw a half turn.