How to make an antikor yourself
How to make an antikor yourself
Sooner or later, any car is exposedwhich destroys the effects of corrosion. By definition, this is the process when metal is destroyed during physical or chemical interaction with the environment. To reduce all the negative consequences, motorists try to protect the car anticorruption. You can drive a car into the service, or apply a protective agent yourself.
You will need
- - Anticorrosive agent;
- - polishing machine;
- - protective film;
- - special sponge.
Instructions
1
Even if you bought a car directly from the assembly line,it must still be treated with an anti-corrosion agent. Pay special attention to those surfaces that are most susceptible to damage. If you do not know what exactly these parts are, get advice in the dealer center or in any service that specializes in the related repair work.
2
Supported machines should be processed at least 1-2 times a year.
3
First, completely wash the car, includingand from below. Experts recommend using water to clean the machine, heated to 60-80 degrees. Sink in three stages. First, soak. It helps to completely soak all the dust that accumulated on the body and bottom of the car. The second stage is the application of chemicals. Their task is to finally clean off the surfaces from contamination. And, finally, rinsing, i.e. final washing machine.
4
Do not apply an anti-corrosion agent tonot dried car. Typically, for drying, it is recommended to blow the machine through a special fan. And do not forget to carefully handle the various joints and internal seams and surfaces. After all, excessive moisture in hard-to-reach places is a quick enough way to get corroded parts.
5
After all the preparatory procedurescarefully inspect the machine. It is very important to identify all defects, cracks, scratches, chips, etc. before processing. All problem areas must be repaired. Small damage to sand, primed and dyed. If there are too deep damages, they need to be straightened, also primed and painted over. If you do not, the car, despite the processing, will still be subject to the spread of rust on the body.
6
The bottom of the machine is also very necessaryto survey. To make it easier, lift the car on a jack or put it on a pit, remove the wheels and put additional light sources under the bottom of the car. In some cases, it is preferable to place an ultraviolet lamp for inspection.
7
Do not forget to protect some of the machine parts beforetreatment - remove the wiper blades, cover the seats in the salon with a film, pull out the entire length of the seat belts and remove all things, including. and a spare tire from the trunk.
8
Protect internal parts with anti-corrosionby means of a nebulizer. So it will be more convenient. And the result is guaranteed better. The body is applied with a sponge. Then rub with a wool circle polishing machine. Allow the machine to dry, the treatment is finished.
