How to clear a monitor screen
How to clear a monitor screen
While using the monitor on itall kinds of blots inevitably appear, for example fingerprints, stains from improper cleaning of the screen, etc. Cleaning the monitor should be approached very carefully, the use of various chemicals and rough materials can lead to a lot of scratches or even damage to the screen.
Instructions
1
Before cleaning the monitorturn it off. On the extinct screen, the accumulated dirt is best seen. In addition, cleaning the operating monitor may damage its screen, there is also the possibility of electric shock.
2
Wipe the monitor body usingClean cloth and mild detergent solution. Apply the solution directly to a rag, do not spray it over the monitor, so you can damage the screen. Do not forget to clean the back of the monitor, as well as all hard-to-reach places, such as fastening points, joints, and connectors. The case of the monitor is made of hard plastic, so it takes a lot of time to clean it.
3
To clean the monitor screen, use a softmaterial that leaves no lint on it and does not scratch it. For these purposes, a microfiber cloth is ideal. Do not use towels, paper napkins and other rigid materials. Wipe the monitor very carefully, do not press on it too much, it can lead to its discoloration.
4
If you use liquid while cleaning the screensolutions, make sure that they are not based on acetone or ammonia. A special solution for these purposes can be purchased at the store or made independently, for example, mixing water and vinegar in equal proportions. Do not apply too much solution to a rag, the fabric should be slightly damp.
5
If the monitor has persistentSpots, take the appropriate portion of the screen more time. To remove such spots, it is necessary to perform a circular method in a systematic way, without pressing the surface too much. This may take a few minutes, but only this way you can get rid of the stain without damaging the screen itself. After removing the stain, wipe the screen with a dry, clean cloth.
6
After cleaning the monitor, give it completelydry out. Do not turn it on if there are wet areas left on it, this will prevent short circuits and protect you from electric shock.
