LovesTheTeam.com

Via the connector you selected, connectsatellite tuner to the TV. On new models of TVs, there is necessarily a suitable connector to which you can connect, but on older ones this may cause problems: they can be connected to the receiver only through the antenna input. After you have connected the satellite tuner (receiver) to the antenna input your TV, you can set up the tuner. Select any channel on which the tuner itself will actually show, and the channels will be switched already on the tuner (receiver). In manual mode, select the channel search function, while the satellite tuner must be connected to the network and connected to the TV, in the tuner display there must be a number, not a clock! The channel setup is finished, save all the settings, after which the satellite tuner (receiver) will be relayed to this channel. For the quality of the image displayed on the screen, the connectors can be arranged in the following order: HDMI, scart, tulips, antenna output. Very important! All cable connections to the tuner must be made when the receiver is deenergized, namely, it is de-energized, and not turned off by the switch on the panel. Carefully read the instructions to the receiver so that you can correctly set up the tuner, there you will find, roughly, the following: MENU => "setup" or "Antenna" or "channel search" or "channel search", then find the menu with the following settings: DiSEqC, 0 / 12V, positioner, LNB, flash tone, and here is the list of settings in the menu to be checked: the satellite you need, in om the menu see whether the satellite configuration of the head of your head. If you have a linear head - the local oscillator frequency is 9750/10600 (universal LNB) If the circular head is the local oscillator frequency 10750 (circular LNB) If C-BAND (si band) is the local oscillator frequency 5150 (C-BAND LNB) All these indicators can be seen and on the label of the satellite head. In the same menu, select the satellite and set the DiSEqC port for it. To connect multiple satellites, as a rule, use the DiSEqC switch to four ports.

Tip 2: How to set up a satellite TV tuner

Tuner is an important part of the satellite television. Without this device, it is not possible to receive and broadcast TV channels. It should be properly set up, following the instructions clearly.

You will need

• - TV;
• - satellite tuner.

Instructions

1

Select one of the connectors on the backpanel of the satellite tuner ("tulip", antenna output, HDMI, scart) and connect the receiver to the TV through it. On modern models, the necessary connector, to which a tuner can be connected, is always found, and in older models the connection is complicated by the presence of only the antenna output, and this affects the quality of the image.

2

Connect the cable to the receiver, having checked beforehand whether the tuner is de-energized. Before proceeding with the setup, you should carefully read the instructions.

3

After connecting to the antenna output of the TVsatellite tuner, set it up. Menu => "antenna" or "tuning" / "setting-searching for channels" or "channel search". Then find the menu with the settings: flash tone, LNB, positioner, 0 / 12V, DiSEqC. Make sure that the desired satellite is found.

4

In the same menu, select the satellite and set the DiSEqC port for it. To connect multiple satellites, use the DiSEqC switch to 4 ports.

5

Select the channel on which the tuner will show. Switching TV channels directly will be done on the tuner itself. In manual mode, select the channel search function. First turn on the receiver on the network. Check that the date display on the tuner display is displayed, not the clock.