LovesTheTeam.com

You will need

• - the ionator;
• -water filter;
• - silverware or silver jug;
• water.

Instructions

1

To ionize Water in an old fashion, no electrical appliancesnecessary. Wash the silver jug. You can do without disinfectants, silver itself is an excellent antiseptic. The jug should be just clean. If you do not have such dishes, use silver forks or spoons.

2

Pour Water in a silver vessel. It is better to get rid of chlorine and other impurities in advance. Use any water filter. Put the jug in a cool, but not too cold place, away from direct sunlight. It is best to keep the silver Water in a dark place. In the light, it quickly loses its properties.

3

Allow the water to stand for about 24 hours. The silver ions will penetrate into it without any interference from you. Upon contact with other substances, silver often loses its properties, since getting into the body can be difficult. But in the water ions retain their activity for a long time. In this case, hydrated silver is formed. It is also called colloidal.

4

If there is no silver jug, pour Water in any glass, porcelain or enamelware. Perhaps not suitable only aluminum vessels. Dip in Water silver spoon or fork. Wash tableware beforehand. In the same way, as in the first case, let the water infuse. The larger the object - the less time it will take. The ancient methods have one significant drawback - it is very difficult to calculate the dosage.

5

If possible, it is best to getionator. It allows you to adjust the concentration of silver in the solution. In addition, you can get ions of super-pure silver. Before proceeding to ionization of water, carefully read the instructions in the device. There are indicated modes of operation and the amount of water.

6

Rinse the working part of the ionator. This should be done with warm water with washing-up liquid. Take care not to get water inside. Metal tube, that is, the cathode, it is better to remove while putting on after the treatment. The silver anode is not removed.

7

Lower the ionator into the vessel with the required amountwater. The water should be slightly above room temperature. The device itself will analyze its electrical conductivity, and accordingly - establish the mode of supply of current. On the ionator there is an indicator light. Watch her closely. After the silver solution is ready, it will go out. If you are interested in watching the ionator during operation, you will be able to notice how the ions drain from the anode. They look like a slightly cloudy train.

Tip 2: How to disinfect water in a well

Purification of the well and water disinfection shouldbe held twice a year. The frequency of these activities depends entirely on the mode of operation of the well and the quality of the water in it. Disinfection of water in the well can be done at any time, but it is better to do this in the summer or spring.

You will need

• - bleaching powder;
• - Brush;
• - a bucket;
• - a rag;
• - long stick.

Instructions

1

Cleaning the well and disinfecting the water extremelyAre necessary, when parts of vegetative organisms, animals or birds enter it, and also in the event that oil gets to water from a deposit. Absolutely no difference what became the cause of water pollution - a mouse, a cat, a dirty boot or a frog. Do not expose your body to danger, because your health is associated with the quality of water used.

2

Before the direct procedure of disinfectionit is necessary to completely drain the water from the well. Pour or wipe the walls of the well with a solution of bleach, for this you can use a stick wrapped with a rag or a normal brush. This solution can be obtained by diluting twenty grams of bleach in a liter of water.

3

When the well is filled with water, fill it with watersolution of bleach. Make a solution, based on the following calculations: for one liter of water you need to take two hundred grams of lime. To prepare a disinfecting solution, take clean dishes and pour in the right amount of cold water (do not use warm water, since chlorine from it quickly evaporates). Then fill in the bleach and cover the dishes tightly. Leave the solution for infusion. Drain the top layer of liquid without turbidity in another bowl.

4

Pour the prepared solution into the well andmix thoroughly with a long stick or buckets, with which water is recruited from the well and poured back. The principle of mixing water is as follows: pick up the full bucket and forcefully pour the water back into the well. Do this procedure five to ten times.

5

After the disinfection procedure is completeDrain the water from the well and replace it with fresh water. And this operation should be carried out until the chlorine smell completely disappears. Then pour the walls of the well with abundantly clean water. Even after this, it is recommended to use water from the well for a while only in boiled form. This may take a little over a week.