How to replace the bearing in a washing machine

How to replace the bearing in a washing machine



Repair of complex household appliances, to whichis a washing machine, it is better to trust professionals and produce in a special workshop. However, if you have some knowledge and feel the strength to cope with the failure, for example, by replacing Bearing, then for this you should carefully and carefully perform all the actions during dismantling and installation.





How to replace the bearing in a washing machine


















You will need




  • - screwdrivers: ordinary and figured;
  • - pliers;
  • - keys on 17 and on 19;
  • - end heads for 7, 8, 10, 13;
  • - hexagon for 6;
  • - a hammer;
  • - the wrench of a candle car key or the like.




Instructions





1


Disconnect the washing machine from the mains andwater supply. Prepare the workplace. It should have good lighting. Remove the top cover by unscrewing the two screws and pulling it toward you. Remove the back cover. Put it aside. Remove the drive belt. Unfold the machine and remove the rubber casing from the front wall, using a screwdriver to open the clamp lock and remove it.





2


Turn the washing machine towards your backside. Carefully disconnect all wires of the motor and heating element, remove the ground terminal. Remove the connector from the engine by releasing the locking latch. Remove the branch pipes from the drum casing by loosening the clamps using a screwdriver and the head on the top 7. Pull the top up with a little effort, unscrewing the screw that secures the level sensor to the casing. Remove the thermal sensor by pushing it out through the nozzle opening. Disconnect shock absorbers, using two keys for 17 and 19 as levers. Do not forget to drown the tab on the bushing.





3


Remove the drum from the springs. Since it is quite heavy, then use outside help. Take the head by 13 and detach the front counterweight. Use a screwdriver to lift it gently. Unscrew the engine mount and remove it by sliding it forward.





4


Take the hexagon by 6 and unscrew the pulley. Remove the rear counterweight. Use a screwdriver to be used as a lever, and carefully remove the counterweight from the guides. Take off the ten. Remove the oil seal with a screwdriver. Remove the locking ring with pliers. Take a hammer and knock out the bearing through the lock of the candle key of the car or similar, evenly and slightly tapping on its perimeter Bearing. Reassemble the machine in the reverse order. The new bearing must be lubricated with a special heat-resistant grease before installation.




























0