How to restore bath enamel

How to restore bath enamel



Unfortunately, over time, the bath loses itsthe original form. Its internal surface is covered with cracks, chips and spots. For today on sale there are various kinds of enamels, applying which it is possible to return former beauty even to very old bath. How to produce Restoring enamels baths?





How to restore bath enamel


















You will need




  • - Abrasive stone;
  • - Moisture-proof sandpaper;
  • - cleaning powder;
  • - enamel;
  • - oxalic acid;
  • - solvent;
  • - soft fabric;
  • - Brush.




Instructions





1


You should know that the new enamel will hold well only on a carefully prepared and low-fat surface. Therefore, before applying the enamel, the surface baths must be cleaned. In this case, you need to remove all scratches, chips and remains of the old enamels.





2


To remove traces of rust from the surface baths it is recommended to use oxalic acid. It must be remembered that acid is poisonous and, working with it, it is necessary to observe security measures. Dilute the powder with water until it is mushy. Apply the mixture gently to the surface. Wait 40 minutes and rinse the acid with water.





3


Apply to the walls and the bottom baths cleaning powder. For this purpose, any means that do not contain chlorine can be used. Thoroughly treat the surface with an abrasive stone. It should be remembered that the better you prepare the surface, the longer the new enamel will hold. Wash off the foam and crumb with warm water. Thoroughly inspect the bathtub. If necessary, repeat the procedure.





4


Reconstitute the deep chips with epoxy resin or a mixture of white nitroenamels with the glue "Supercement".





5


Sand the bath with water-resistant sandpaper. Remove dust and degrease the surface with a solvent.





6


Plug the drain hole and dial the fullhot water bath. Allow the water to stand for 10-15 minutes. This is necessary in order to wash off the degreasing compound. Drain and wipe the walls and bottom baths Dry with a soft cloth. Make sure that the surface is absolutely smooth and has a matte finish.





7


Prime the bath. To do this, carefully read the instructions attached to the enamels. Prepare and carefully apply the first primer with a natural hair brush. As a rule, the primer consists of the enamels and hardener included in the delivery. Take care not to create bubbles and stains during operation. Allow the formulation to dry for 15-20 minutes.





8


Apply the base coat enamels with the help of a brush. It is necessary to know that the required number of layers and the drying time of the composition depend on the manufacturer and are specified in the attached instructions.




























0