How to make a shelf for vases 2109
How to make a shelf for vases 2109
Car VAZ 2109 from the factory does not have audioshelf. That's why you have to do it yourself. Correctly made shelf will contribute to a good sound of car speakers.
Instructions
1
First, mark the shelf template. As a template, you can take the decorative upholstery of the rear shelf. After that you will need a ruler and a tape measure. With their help, you can adjust the dimensions of the future acoustic shelf. Also note the holes for the speakers immediately. Layout of the template needs to be given a lot of attention. This stage of work is almost the most difficult and responsible. It is best to make a little larger than necessary. You can always cut off excess parts. Try to make sure that the holes for the speakers match perfectly.
2
Try to put shelf to the intended place. If necessary, cut a few centimeters from each side. For work it is necessary to have 2 sheets of plywood. The second sheet is cut in the image and likeness of the fitted first sheet. After that you will need to glue them well. Glue the entire surface of both sheets. As a result, you should get a solid board. Its thickness is usually 15 mm. Pay attention to the speakers. They can protrude strongly above the plane of the shelf. In any case, this will make it harder for the carpet to tighten the shelf. To solve the problem you will need another sheet of plywood. Saw it on the shape of the finished shelf. Under the speakers make holes larger diameter.
3
The shelf should fit snugly against the body. For this purpose, apply a thick, but at the same time deformable material to its lower side in certain places. Macroflex is recommended. Soak it in the water in advance. After hardening, this material has good strength. You can cut it with a knife already in place.
4
As a result, you must have a fitted shelf with the speakers installed. It remains only to sew it with a carpet and mount it into place. Cut the carpet into the size and shape of the shelf. To each edge, add 5 cm. The fabric should be bent and fixed to the ends of the shelf. Usually, U-shaped clips are used for fastening.
