LovesTheTeam.com

You will need

• - cleanser;
• - capacity, commensurate with the filter;
• - oil for impregnation;

Instructions

1

Pull out filter zero resistance from the body and detach the inlet pipe from it. Using a medium-hard brush, clean the surface filtera. Be careful not to damage the rubber parts of the part.

2

For some species filterA spray detergent is used. It must be sprayed onto the entire surface of the part and left for 10 minutes until completely dry.

3

To cleanse filterIt is recommended to use wet cleaning for large sizes. Take a suitably sized container and fill it with a special cleaning solution. To clean all sections filterAnd, it must be rotated in the liquid for 3-5 minutes. After washing, put filter on a hard surface for 10 minutes. This time is necessary for complete soaking filterbut a cleanser.

4

To clean flat filterbut, it's enough just to immerse it for 5 minutes in the cleansing composition. It should be ensured that the solution completely covers the surface filtera.

5

After filter completely impregnated with a cleaning solution, it must be washed with running water. But note that the pressure of the water head should be minimal.

6

After washing filterand it must be thoroughly dried. However, drying should occur in natural conditions. Do not use artificial drying methods, such as a hair dryer or a compressor. The impact of high pressure can damage filterlearning elements. Dry filter must be in a strictly horizontal position on a solid surface.

7

After complete drying, apply to the surface filterbut a special oil for impregnation. This composition helps filteru detain dust and pollution. Do not use motor oil or any other oil for this purpose. Such operation filterbut breaks the proper engine cleaning system.

8

Install filter in place. Carefully fasten it. If you use the car on roads with increased dustiness, it is necessary to apply to the body filterbut a special hermetic compound.