LovesTheTeam.com

You will need

• - Instructions for the lock for a particular model.

Instructions

1

Open the front door to the house and close the lock. All actions are performed on the inside of the doors. In order to change the code from the outside, you will have to remove the doors along with the canvas.

2

Dial the code combination that was to yougiven when installing the lock. Find the label for the code change, which is indicated on the disk. The code must be at the top of the code to change the code. Then insert the individual key as far as it will go into the hole on the door from the inside.

3

Rotate the key smoothly ninety degrees clockwise to the "CHANGE" position. Then start installing the new code, and the key must remain in the lock.

4

Write down your new lock codedo not forget it during the installation process. Rotate the dial four times against the clockwise direction and set the initial digital value of the new lock code opposite the label to change the code. Set the second digit of the new code by rotating the dial clockwise against the label three times. The third digit is set opposite the label for changing the code, turning the lock dial against the clockwise two times.

5

Turn the special key to the"INSERTION" and pull it out. Without much physical effort, you just installed a new combination lock on your door. If you violate the sequence of actions specified in the instruction, this can lead to locking the lock and loss of its operability.

6

If you are unable to conduct such an operationyourself, invite a specialist from a company that provides services of this nature. There is a large number of companies whose priority activity is installation, conversion and changing of code locks. In the shortest time, security professionals will determine the type of encoding and change the code of your lock, in an environment of complete confidentiality.

Instructions

1

Open the car with the center lock, giving voltage to the on-board network. To do this, remove the transparent casing from the external light and remove the light bulb. Break the glass of the same burnt out bulb and install it instead of running. Apply voltage from a well-charged battery to the projecting antennae. This method is effective only if the battery is discharged after you left the parking lights or dipped lights for a long time.

2

Replace the battery with a new one ifblocking the central lock was the fact that the old exhausted its resource. Since you can not open the hood of the car simply, you will build a hook from the wire and try using it to reach the locking levers or hook the cable going from the hood lock to the left wing. Sharply pull the cable, picking it up with a wire near the radiator or left headlamp.

3

Place the battery near the hood. Connect one of the cigarette lighter wires to the negative terminal and vehicle weight. Connect the second wire to the positive terminal and connect it to the "plus" starter. Another person at this moment should open the car with a key or key. Prepare yourself in advance to re-occur such a situation, providing a special connector or wire, which can be easily supplied external power supply, if necessary.

4

Use the help of companies representingemergency car breakdown services, if you can not unlock the car yourself or you want to avoid damages that may arise as a result of your actions. If the central lock was broken, the specialists of the automobile technical assistance will repair it.

Instructions

1

The simplest, but also the most unpleasant way isbreak the glass of the car, put out your hand and open the door from the inside. Use this solution only in extreme cases. In addition to the variant "there is no better scrap", there are more loyal methods to cope with the problem that has arisen. If you still decided to beat the glass, then remember: do it better not by hand, but by some weighty object that can always be found nearby. Also do not break the front or rear windows. Their replacement will cost you much more than replacing the glass from the rear passengers. Do not hit the glass on the driver's side. This will prevent you from driving (especially in winter) by the vehicle. If you decide to break the glass by hand, then wrap it with some kind of rag or jacket, so as not to get injured by broken glass.

2

Call for help and help on the roads. In a short period of time you will receive a support car with a qualified craftsman who will open the door of your car with a special tool in a matter of minutes. Only here will cost such a call in penny for your budget. But at the same time, your car will not suffer a single drop, as in the first case.

3

If the house has a spare set of keys, thencall a mobile phone from someone at home from your cell phone. Ask the person at home to unlock the car door by pressing the appropriate button on the key of the car. Simultaneously, lift your mobile to the door and hold it about 30 cm from it. The door of the car will have to open. In this case, the remoteness of a person with a spare set of keys from a locked car door does not matter. If the call to the mobile phone has passed, then the door should open. Remember that this way to open the door may not work on modern expensive cars with a "heaped" security system.

4

Remove the seal between the door and the sideglass of your car. Push a pre-prepared wire, one end of which is bent in the form of a hook, into the gap between the door and the glass and try to pick up the lock drive lead.

Instructions

1

Remember that even with a discharged batterye, when the alarm does not work, you can open the door mechanically with a key. Once inside the car, it is necessary to open the hood and remove the discharged battery. Further all will depend on the period during which the batteryand how long it stood unloaded. If battery discharged recently, you can try to charge it or light it from another machine using high-voltage wires. If the machine has stood for a long time with discharged batteryoh, then you need to replace it by buying a new one. After replacing the battery, be prepared that the car's security alarm will work. Disconnect it from the keychain. After that, the doors in your car will open as before.

2

If you need to get into your car with a low batteryoh, and you do not have the keys, then contacta maintenance station or call the technical assistance service on the road by the mobile phone. Be ready to show the documents on the car. Without them, you will be denied autopsy of your car and can be mistaken for a hijacker.

3

If battery Your car is empty, the doors are closed, and the keys tocars are in the cabin, do not panic. Find the wire and bend one of its ends so that the hook turns out. Dip the resulting hook into the slot between the glass and the door of the car and hook the lock drive. Smoothly, but with an effort, pull it upward. The door will open. If there is no time to look for a wire or you are in such a situation that there is simply nowhere to find it, then remove the janitor, pull out the spoke and bend one of its ends. Get a hook. How to proceed, you already know.

4

Remember the ancient Russian instrument,opening all doors and locks on any machine. This is a hammer (or its substitute). With a hopeless option, its application can be a way out of the situation. Just be careful and do not cut yourself with glass shards.

You will need

• - spare set of keys;
• - cellular telephone;
• - 2 wooden spatula;
• - the camera;
• - the pump;
• - Steel wire or a spoke from the janitor.

Instructions

1

If you slam the keys in the car, but in your homethere is a spare kit, call your household on your mobile phone and ask for a spare car key. Rise not more than 30 cm from the car, without disconnecting the cell phone, at this time a person with a spare kit should press unlock, having previously carried the key to the switched on cellular phone. The car door will open.

2

If the central locking fails, remove thecar with alarm. Basically, this function does not affect the breakage of the lock. Provided that the car is equipped with a remote start, start it with a keychain. Take 2 wooden kitchen blades, one gently insert between the center pillar and the top of the driver's door, place the other blade under the first. Quietly tilt the door, spreading the blades in different directions to form a small gap. You can use another tool, preferably wooden, so as not to damage the coating of the body. In the resulting slot, put the folded in half cardboard between the sides of which push the steel long wire. By operating the wire, try to get the button of the window regulator (this will be easier when the car is driven) or the button of the central lock.

3

Open the front door through the car window. To do this, make a gap between the glass and the base of the door, so thick that steel wire can pass through it. Do not use a screwdriver, it can scratch the glass. Take the camera and pump, slide the camera into the slot and pump it up. In the resulting gap, insert the wire, which you try to engage the lock drive lead. So you can open the door. In the absence of wire, you can use the janitor. Remove the spoke from it and bend one end with pliers to get a hook, do the above procedure.